Meco 2200 Benutzerhandbuch

Wire is shorting (sparking
between ignitor wire and
electrode

Replace ignitor wire/electrode assembly (Call the Customer
Service Department @ 1-800-251-7558)

13

Burner not assembled
correctly

Not pausing long enough
before clicking the Igniter

No spark

LP gas cylinder is empty

Excess flow valve tripped in
Regulator

Obstructions in burner

Electrode and burner are wet 

Wire is loose or disconnect-

See Assembly Instructions for installing the Burner.

The spacing between electrode and Burner ports should be
approximately 3/16”. Make sure wire connections are secure
and burner is attached securely to brackets.

Dispose of empty cylinder and replace with a full one.

Turn Control Knob to “OFF” position. Wait five minutes.  Relight
LP gas grill. If flame remains to be low, turn off gas.
Disconnect the Lp gas cylinder from the Regulator. Reconnect
the LP gas cylinder to the Regulator. Perform a leak test.
Relight grill. This will reset the excess flow valve.

Clean burner (See Burner Maintenance in Care and
Maintenance section of this manual)

Dry electrode with clean cloth

Reconnect the wire

When lighting the Burner, push in and turn the Control Knob
counterclockwise to “I” when you feel resistance. Pause 4
seconds, then push in and turn the Control Knob until a click is
heard.

Your Gas Grill comes with convenient wheels and a slide
out handle for roll-away transport. When the Grill has
completely cooled, and the Grill and all the parts are clean:

· Disconnect the LP cylinder from the regulator.

· Fold and strap the Grill side tables over the closed Hood. 

· Slide the Left Handle Bar back under the grill.

· Remove the leg shelf. Release the locking springs and 

lower the left end of the Leg Shelf. Lift the other end off 
the mounting Hooks on the right legs. 

· Swing the Gas Regulator up into its storage position  

behind the front panel of the Grill and clip it into place. 
(FIG. 24)

· Fold Legs to locked position under Grill. 

· Store Leg Shelf back in the bottom of the grill and snap 

into place.

· Grasp the Right side Handle Bar; lift Grill on wheels and 

roll the grill away to storage area. (FIG. 25) DO NOT