Meco 2200 Benutzerhandbuch

Seite von 16
Use only 1 lb. propane cylinders or 20 lb. propane
cylinders with proper adaptor hose as specified above.
Use of other gas cylinders could cause gas leak or fire.
· Read manufacturer’s instructions and warnings on LP
cylinder.
· Never use an LP gas cylinder if it shows signs of: dents, 
gouges, bulges, fire damage, corrosion, leakage, 
excessive rust or other forms of visual external damage; 
it may be hazardous and should be checked by a liquid 
propane supplier.
· Keep children away from LP gas cylinder at all times.
· Do not use, store, or transport the LP gas cylinder where 
it would be exposed to heat, sparks or flame. The relief 
valve may open which will allow  a large amount of
flammable gas to escape. Never leave an LP gas
cylinder inside a vehicle which may become overheated 
by the sun.
· WARNING!  Never store an LP cylinder indoors.  
Storage of an outdoor cooking gas appliance indoors is 
permissible only if the cylinder is disconnected and
removed from the outdoor cooking gas appliance.  LP
Cylinders must be stored outdoors out of the reach of
children and must not be stored in a building, garage, or
any other enclosed area.
· WARNING!  Never store a spare LP gas cylinder 
near the grill. All spare and disconnected LP gas 
cylinders must have safety caps installed.
· LP gas is not natural gas. The conversion or attempted 
use of natural gas in an LP unit or LP gas in a natural 
gas unit is dangerous and will void your warranty.
· WARNING! Never attempt to repair or refill a 1 lb LP
gas cylinder valve. Repairing or refilling could cause a 
hazard or explosion. Replace gas cylinder with a spare.  
· Using a repaired or refilled  1lb. LP Gas Cylinder will void 
the warranty.
· When transporting an LP gas cylinder, keep it secured 
in an upright position with the protective cap on. 
Connecting/ Disconnecting LP
Gas Cylinder to Grill
· Always check for gas leaks when you disconnect
and  reconnect the regulator to the LP gas cylinder,
especially after a period of storage (for example, over 
winter).
· Check tubes leading into the burner for blockage from 
insects, spiders, or food grease before using.
· Check Regulator Hose or other supply hoses for 
cracking, brittleness, holes, or leaks. Make sure there 
are no sharp bends in the hose. 
· Make sure Regulator Hose does not contact hot metal 
surfaces. 
REGULATOR ASSEMBLY
· Using a hose and regulator assembly that has not 
been supplied by the manufacturer of this LP gas 
grill, could result in serious bodily injury or property 
loss.
· Wash the Cooking Surfaces with a mixture of hot water 
and dish detergent. Do not use an abrasive scrubber. This 
product is non-stick coated and harsh cleansers will ruin 
the finish. Be sure to re-install the Ribbed Cooking 
Surface with the grease drain toward the rear over the 
grease cup.
· Empty the Grease Cup after each cooking session so 
excessive grease does not accumulate. Do not jerk the 
grease cup out with grease in it. (See FIG. 19) 
Wash 
Grease Cup same as Cooking Surfaces.
· Make sure Grease Cup is in place before each grilling 
session. (FIG. 19)
FIG. 19
·  Empty the Grease Cup after each cooking session 
so excessive grease does not accumulate. Failure to 
remove grease may result in a grease fire in the Cup 
or Bowl.
·  Allow grill and grease in Grease cup to cool before 
emtying Grease Cup.
·  Never light the LP gas grill without the Grease Cup 
in place.
Use Clean
and Empty
Grease Cup
before each
grill session.
8
· Use only the hose and regulator assembly that has been 
furnished with this LP gas grill. If the hose and regulator
assembly is not working properly and you need a  
replacement, contact the manufacturer (1-800-251-7558).    
· Inspect the hose before each use. If the hose is cut or 
damaged or shows signs of excessive abrasion or wear, 
do not use the LP gas grill. Contact the manufacturer, as 
the hose must be replaced with an assembly specified by 
the manufacturer prior to the further use of the LP gas 
grill.
Preparation Before Cooking
Install and remove with steady pressure to
snap into grill body. To avoid spillage, do not
jerk grease cup with grease in the cup.