Earthquake Sound PH800W/2 Benutzerhandbuch

30A Fuse

S p e a k e r   O u t p u t s
Minimum 4 Ohm Mono

The gain knob is not a volume control. 
It is designed to match the input level 
of  the  amp  to  the  output  level  of  the 
source unit. Over driving -clipping- the 
input  stage  of  the  amp  will  cause 
damage to the amplifier (Please refer 
to table for settings).

Crossed  RCA  level
outputs,  can  be  used
to feed other amplifiers
in the system.

3-way switch feeds RCA
outputs a low-pass full-
range or high pass signal.

Set Xover knob to 
Minimum (20Hz), &
set Xover switch to 
Full Range

The PH1000W/2 is designed to
operate in stereo or mono mode. When
used in stereo applications, a minimum
load of 2 ohms per channel is required.

The PH1000W/2 is designed to
operate  in  mono  mode.  When
bridging  the  two  channels,  a 
minimum  load  of  4-ohms  is 
required.

RCA level inputs, with
a range of 0.2V to 5V.
RMS.

+18dB boost @ 45Hz
designed to shape/
boost the response 
curve in a low-pass
mode application.

+12dB boost @ 
12kHz essential 
boost for high-pass 
amplifier applications

3-way switch 
runs the amp 
in low-pass, 
full-range or 
high-pass 
mode.

To car chassis / ground

To remote turn on / trigger

To battery (+)

FC6.2

Tweeter

FC6.2

Tweeter

FC6.2 Midrange

FC6.2 Midrange