Dirt Devil Upright Bag Vacuum Cleaner Benutzerhandbuch

Loop belt around motor shaft.

Insert brush roll into holder #1

then #2.

Replace nozzle guard.

3.

4.

5.

Lift and remove brush roll.

Remove nozzle guard.

2.

#2

#1

T

O REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.

1.    To remove nozzle guard: turn power nozzle over and insert finger into openings near an arrow as shown (Diagram 1). Squeez

e clip and pull nozzle guard 

toward you.

1.    Be sure belt is of

f motor shaft.   

2.    Lift and remove brush roll (Diagram 2).   
3.    Dispose of old belt.

1.    Loop belt around motor shaft (Diagram 3).  

2.    Slip brush roll through belt. Place belt on raised area of brush roll without bristles.   
3.    Pull brush toward you and insert into side holder #1 and then #2 (Diagram 4).   
4.    Replace nozzle guard. Match the front tabs to the slots on the nozzle base. Swing down to snap hooks. Press firmly on ent

ire nozzle guard to fit into place 

(Diagram 5).

BE SURE BEL

T IS NOT TWISTED AND BRUSH ROLL ROTA TES SMOOTHLY.

7

I

nsert the clip into one of the grooves(one front, one back)

on the canister. Repeat fo r remaining groove and clip.

Y

our Breeze

™

Vision

®

Canister can now be carried for

your cleaning convenience.

1.   Insert clips into grooves (one front, one back) on top of canister (Diagram 1).

2.   Your Breeze

™

Vision

®

Canister can now be carried on your shoulder while cleaning above the floor (Diagram 2).

3.   To remove each clip from the cleaner, squeeze the clip together and pull up and out of the slot.   

1.

2.

1.