Smeg DO10PSS-5 Benutzerhandbuch

Seite von 25
Instructions for the user
 
 
 
47 
13.3.4
  Looking after the self-cleaning liners 
 
 
The liners should not be cleaned with abrasive creams or ordinary detergents. Use a damp sponge 
only, so as not to damage the special characteristics of the enamel which coats the liners. 
13.3.5
  Assembling the self-cleaning liners 
 
1.
  Remove all accessories from the oven; 
 
2.
  Remove the side grilles (fig.1); 
3.
  Extract the side liners “F” and “G”(fig. 2); 
4.
  Remove the back panel “A” after undoing the threaded ring-nut “C” (fig. 2). 
5.
  Reassemble the panels, restoring them to their original position. 
 
             2)
 
1)
 
To remove the self-cleaning liner at the back of the small oven, extract it from the two screws on the 
bottom of the oven. To replace it, align the two holes on the liner with the two screws on the bottom 
and pull down until engaged.
 
13.4  Door glass 
 
 
The door glass should always be kept clean. Use absorbent kitchen paper to clean. In case of tough 
spots, clean with a damp sponge using regular detergent. This oven door is air cooled. Care should 
be taken not to use excess moisture for cleaning, and avoid spillage through the vents.
 
 
MAINTENANCE 
 
The oven may require maintenance or replacement of parts subject to wear such as seals, bulbs, and 
so on. The following instructions describe how to carry out these minor maintenance operations.
 
Before any intervention, disconnect the power supply of the device. 
 
13.5  Replacement of light bulb 
 
 
Remove the bulb protector A by turning anticlockwise and change bulb B with a similar one. Re-fit the 
bulb protector A.
 
 
 
 
Only use oven bulbs (T 300°C).