Desa RV125EDI Benutzerhandbuch

5

This heater is furnished with wheels, handles, and an interrupter. These items and
the mounting hardware are found in the shipping carton.

• Medium Phillips Screwdriver
• 3/8" Open or Adjustable Wrench
• Hammer

1. Slide axle through wheel support frame. Install wheels on axle.

IMPORTANT:

When installing wheels, point extended hub of wheels toward

wheel support frame (see Figure 2).

2. Place cap nuts on axle ends. Gently tap with hammer to secure.
3. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is

over wheels. Line up holes on fuel tank flange with holes on wheel support
frame.

4. Place front handle and rear handle on top of fuel tank flange. Insert screws

through handles, fuel tank flange, and wheel support frame. Attach nut finger
tight after each screw is inserted.

5. After all screws are inserted, tighten nuts firmly.
6. Place interrupter onto combustion chamber. Secure with two screws. Save two

additional screws for mounting vent pipe.

Screw

Hot Air
Outlet

Fuel
Tank
Flange

Wheel
Support
Frame

Wheel

Cap Nut

Nut

Axle

Extended
Hub

Air
Inlet

Rear
Handle

Front
Handle

Screw

Interrupter