Philips MCM3000/12 Benutzerhandbuch

19

 • Reduce the distance between the remote

control and the unit.

 • Insert the battery with its polarities (+/–

signs) aligned as indicated.

 • Replace the battery.
 • Aim the remote control directly at the

sensor on the front of the unit.

No disc detected

 • Insert a disc.
 • Check if the disc is inserted upside down.
 • Wait until the moisture condensation at

the lens has cleared.

 • Replace or clean the disc.
 • Use a finalized CD or correct format disc.

Cannot display some files in USB device

 • The number of folders or files in the USB

device has exceeded a certain limit. This

phenomenon is not a malfunction.

 • The formats of these files are not

supported.

USB device not supported

 • The USB device is incompatible with the

unit. Try another one.

Poor radio reception

 • Increase the distance between the unit

and your TV or VCR.

 • Fully extend the FM antenna.
 • Connect an outdoor FM antenna instead.

Timer does not work

 • Set the clock correctly.
 • Switch on the timer.

Clock/timer setting erased

 • Power has been interrupted or the power

cord has been disconnected.

 • Reset the clock/timer.

8 Troubleshooting

Warning

 

•

Never remove the casing of this apparatus.

To keep the warranty valid, never try to repair

the system yourself.
If you encounter problems when using this

apparatus, check the following points before

requesting service. If the problem remains

unsolved, go to the Philips web site (www.

philips.com/welcome). When you contact

Philips, ensure that the apparatus is nearby

and the model number and serial number are

available.
No power

 • Ensure that the AC power cord of the

unit is connected properly.

 • Ensure that there is power at the AC

outlet.

 • As a power-saving feature, the system

switches off automatically 15 minutes

after track play reaches the end and no

control is operated.

No sound or poor sound

 • Adjust the volume.
 • Disconnect the headphones.
 • Check that the speakers are connected

correctly.

 • Check if the stripped speaker wires are

clamped.

No response from the unit

 • Disconnect and reconnect the AC power

plug, then turn on the unit again.

 • As a power-saving feature, the system

switches off automatically 15 minutes

after track play reaches the end and no

control is operated.

Remote control does not work

 • Before you press any function button,

first select the correct source with the

remote control instead of the main unit.

English

EN

MCM3000_UM_12_Book 1.indb   19

8/14/2012   2:57:20 PM