Electrolux E36GC70FSS Benutzeranleitung
10
Care and Cleaning
Cleaning Recommendations
Surface Type
Cleaning Recommendation
•
Painted and Plastic
Control Knobs
For general cleaning, use hot, soapy water and a cloth. For more difficult
soils and built-up grease, apply a liquid detergent directly onto the soil. Leave
on soil for 30 to 60 minutes. Rinse with a damp cloth and dry.
DO NOT
use abrasive cleaners on any of these materials; they can scratch.
•
Porcelain Enamel
• Burner Grates, Burner Caps
Clean burner grates in the dishwasher and dry upon removal.
Gentle scouring with a soapy scouring pad will remove most spots. Rinse
with a 1:1 solution of clean water and ammonia. If necessary, cover difficult
spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse
with clean water and a damp cloth, then scrub with a soap-filled scouring
pad. Rinse and wipe dry with a clean cloth. Remove all cleaners or the
porcelain may become damaged during future heating.
DO NOT use
spray oven cleaners on the cooktop.
•
Surface Burners
• Burner Head
The holes in the burners of your cooktop must be kept clean at all times
for proper ignition and a complete, even flame.
Clean the burner holes
routinely with a small gauge wire or needle and especially after bad
spillovers which could clog these holes.
To remove, clean and replace sealed burner units; follow the instructions
To remove, clean and replace sealed burner units; follow the instructions
in General Care & Cleaning section under
Cleaning the Burner Grates,
Burner Caps, Burner Heads. For stubborn stains, scrub with soap
and water or a mild abrasive cleanser and damp cloth. Dry the burners
thoroughly in a warm oven for 30 minutes. Then replace them, making sure
they are seated and level.
DO NOT put burner units in the dishwasher.
•
Stainless Steel
Clean
stainless steel with hot, soapy water and a dishcloth. Rinse with
clean water and a cloth.
Do not use cleaners with high concentrations
of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only
use kitchen cleaners that are especially made for cleaning stainless steel.
Always be sure to rinse the cleaners from the surface as bluish stains
may occur during heating that cannot be removed.