Epson 20020 Benutzerhandbuch

2. Some programs work at only one operating speed. Your

computer can run at either 8 MHz or 12 MHz. Check your
software manual to see if your application program must

run at the slower speed and change the CPU operating

speed if necessary. See “Changing the Operating Speed” in
Chapter 3 for instructions.

3. If you have entered an MS-DOS command that you want

to stop, there are special key combinations you can type to

signal MS-DOS to stop what it is doing. These methods
may also work in your application programs.

To interrupt an MS-DOS command while it is executing,

try one of the following commands:

Hold down Ctrl and press C

Hold down Ctrl and press 

Break.

4. An application program can occasionally lock the

computer, making it unresponsive to the keyboard. If your
computer does not respond when you type on the keyboard,
you can reset it. Follow the instructions under “Resetting

the Computer” in Chapter 3.

Below are some general steps to follow if you are having
difficulty with your printer. If the problem persists and you
need more detailed information, check your printer manual.

1. If your printer does not work correctly immediately after

you install it, check that the printer has power and is
properly connected to the computer. Check Chapter 1 of

this manual or your printer manual for instructions on how

to connect your printer to the computer.

Also make sure your printer has paper in it, since many
printers cannot operate without paper.