Ariens 932037 - 724 Benutzerhandbuch

GB - 13

See Figure 9 for all Controls and Features 
locations.

Squeeze the Traction Drive Clutch Bail against 
the Handlebar (1) to engage wheel drive for 
propelling unit. Forward speed will vary 
according to snow depth and moisture 
content. 

Release bail (2) to stop movement.

NOTE: When traveling to or from the area to 
be cleared, press down on the handlebars 
enough to raise the front of the unit slightly off 
the surface. Engage the traction drive clutch 
without engaging the attachment drive clutch.

Squeeze Attachment Clutch Bail against 
handlebar (1) to engage attachment. Release 
both clutch bails (2) to disengage power and 
apply brake to attachment.
IMPORTANT: If the belt squeals when the 
attachment clutch bail is engaged, the 
attachment drive may be frozen. Immediately 
release the attachment clutch bail and move 
the unit into a heated area to thaw.

Key Switch has two positions:
1. “Stop” - pulled out

2. “Run” - pushed in

NOTE:  DO NOT twist key 
after it is inserted.

Pushing the primer bulb in adds 
fuel for easier engine start. 
Refer to Starting and Shut Off.

The Speed Selector controls the unit travel in 
a forward or reverse direction when positioned 
in notch of speed.

Forward:

(6) Fastest
(1) Slowest

Reverse: 

(1) Slow

(2) Fast

IMPORTANT: DO NOT change motion from 
forward to reverse with clutch engaged. 
Forward speed can be changed without 
declutching.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: To avoid injury to hands 
and feet, always disengage clutches, 
shut off engine, and wait for all 
movement to stop before unclogging 
or working on snow thrower.
Keep hands and feet away from auger 
and impeller.

1

2

OL2702

OL1692

1

2

1

2

OS1431

OS1321

1

2

1

2

3

4

5

6

OS2400