Snapper NZM27612KH Benutzerhandbuch

 

4.  Remove inside nuts that secure chain to front lift 
arm. See Figure 4.10. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

5.  Remove inside nuts that secure chain to rear lift 
arm. See Figure 4.11. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

6.  Remove deck drive belt from around deck pulley. 
7.  Remove bolts and nuts to disconnect both stabilizers 
from mower deck and power unit.        See Figure 4.12 & 
Figure 4.13. 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

8.  Remove wooden blocks from underneath deck 
and roll/slide deck from underneath power unit. 
9.  Reinstall deck in reverse order, of which it was 
removed. Tighten all nuts and bolts securely.  

 
4.7  HYDRAULIC FLUID FILTERS 
IMPORTANT: REFER TO SECTION “HYDRAULIC 
SYSTEM PURGING” BEFORE PERFORMING FILTER 
MAINTENANCE. 

The first filter change is recommended at 200 hours. 
After the first change, the recommended interval is 
every 500 hours. Replace both with approved filters 
only (Snapper P/N 27164). Install following 
instructions provided with the filter. Add SAE 20W50 
oil to bring the level in the reservoirs to 1 ½” below 
top of filler neck. Run machine for several minutes 
and re-check fluid level. Add oil as needed.