Dixon 36 Benutzerhandbuch
DIXON
-43
MAINTENANCE
Pump Belt
Replacing EZT (E-Series Zeroturn Transaxle) belt
Park the mower on a level surface. Engage the
Park the mower on a level surface. Engage the
parking brake.
EZT belt removal
EZT belt removal
NOTE: Be careful not to damage the fan blades on
the EZT´s as this can affect cooling or damage the
EZT´s
Remove the deck belt (see Deck Belt Removal
Remove the deck belt (see Deck Belt Removal
•
in this section of the manual).
Create slack in the belt by removing the spring
Create slack in the belt by removing the spring
•
on the pump idler arm.
The belt should now be able to be removed
The belt should now be able to be removed
•
from the engine pulley and EZT pulleys.
Belt installation
Wrap the EZT belt around the EZT pulleys
•
Route the belt around the inside of the idler
•
pulley.
Wrap the belt around the engine pulley.
Wrap the belt around the engine pulley.
•
Reattach the spring on the pump idler arm.
•
Install clutch on to engine shaft (pulley side
•
down) make sure key is installed and align
the clutch anti rotation tab into slot on clutch.
Secure clutch, install wire.
Reinstall the deck belt onto the electric clutch
Reinstall the deck belt onto the electric clutch
•
belt (see Deck Belt Removal in this section of
the manual).