Husqvarna 575XP Benutzerhandbuch

36 – 

English

The oil pump is adjustable. Adjustments are made by turning 
the screw using a screwdriver or combination spanner. The 
machine is supplied from the factory set to 1 turn open. 
Turning the screw clockwise will reduce the oil flow and 
turning the screw anti-clockwise will increase the oil flow.

Recommended settings:

These recommendations apply to Husqvarna’s chain oil, for 
other chain oils increase the oil flow by one step.

To keep the working temperature as low as possible the 
machine is equipped with a cooling system.

The cooling system consists of:

1

Air intake on the starter.

2

Air guide plate.

3

Fins on the flywheel.

4

Cooling fins on the cylinder.

5

Cylinder cover (directs cold air over the cylinder).

Clean the cooling system with a brush once a week, more 
often in demanding conditions. A dirty or blocked cooling 
system results in the machine overheating which causes 
damage to the piston and cylinder.

Note! The cooling system on a chain saw with catalytic 
converter must be cleaned daily. This is particularly important 
on chain saws with catalytic converters, because the higher 
exhaust temperature requires efficient cooling of the engine 
and the catalytic converter unit.

Centrifugal cleaning means the following: All air to the 
carburetor passes through the starter. Dirt and dust is pushed 
out by the cooling fan.

IMPORTANT! In order to maintain operation of the centrifugal 
cleaning system it must be regularly maintained. Clean the air 
intake to the starter, the fins on the flywheel, the space around 
the flywheel, inlet pipe and carburetor compartment.

Bar -15":

1 turn from the closed position.

Bar 15" -18": 2 turns from the closed position.

Bar 18" -24": 3 turns from the closed position.

Bar 24" -:

4 turns from the closed position.