Snapper ZF5201M Benutzerhandbuch

7. Turn ball joint in or out until ball joint
anchor hole aligns with mounting hole.
Reinstall bolt and tighten securely. Use
same procedure on other caster wheel. See
Figure 5.3.
8. Reinstall bolts and tighten securely.
9. Remove blocks from under front of deck.
10. Side to Side Level: Check blade tips by
rotating blades until tips are pointing to the side
of the deck. Check the measurement of
outside blade tips to the ground on both blades.
The measurement of each outside blade tips
should be within 1/8” of each other.
11. Front to Rear Level: Check blade tips by
rotating blades until tips are pointing to the front
and rear of deck. Check the blade tip
measurements of each blade. Front to rear
measurement should be 1/4” to 3/8” higher in
the rear.

5.3 PARKING BRAKE ADJUSTMENT
5.3.1. The park brake can be adjusted by removing the
park brake rod from the park brake lever and rotating
clockwise to increase brake tension. See Figure 5.4.
When properly adjusted the park brake lever should
require 18 to 22 pounds force to set the brake. If this
adjustment does not result in proper brake action,
contact your authorized Snapper dealer for corrective
action. See Figure 5.4.

DO NOT  operate machine if brakes are not
functioning properly.

Refer to the engine owner’s manual for engine
adjustments and/or repairs.