Snapper SPE140KW Benutzerhandbuch

Seite von 32
 
IMPORTANT SAFETY INSTRUCTIONS 
 
OPERATION  
1.  DO NOT put hands or feet near or under rotating 
parts. Keep clear of the discharge area while the 
engine is running. 
2.  Stop Blades when crossing gravel drive, walks, 
and under any conditions where thrown objects 
might be a hazard. 
3.  Mow only in daylight or good artificial light. 
4.  DO NOT operate the machine while under the 
influence of alcohol or drugs. 
5.  After striking a foreign object or if the mower 
vibrates abnormally, STOP the blades and 
engine. Remove the key. Disconnect and secure 
the spark plug wire. Inspect the mower for any 
damage and repair the damage. 
6.  DO NOT operate machine near drop offs, 
ditches, or embankments. Operator could lose 
footing or balance. 
7.  STAY ALERT for holes and other hidden 
hazards. Tall grass can hide obstacles. Keep 
away from ditches, washouts, culverts, fences 
and protruding objects.  
8.  DO NOT operate machine on wet grass. Always 
be sure of your footing: keep a firm grip on the 
handle and walk: never run. Slipping could 
cause injury. 
9.  DO NOT leave the machine with the engine 
running. STOP BLADES, STOP ENGINE and 
REMOVE KEY before leaving the operator 
position for any reason. 
10.  Before cleaning, repairing, or inspecting make 
certain blades, engine and all moving parts 
have STOPPED. Remove key and secure spark 
plug wire away from spark plug key to prevent 
accidental starting. 
11.  STOP BLADES and ENGINE and make sure 
blades have stopped before removing grass 
catcher or unclogging mower to prevent loss of 
fingers or hand.  
12.  Blades must be OFF except when cutting grass. 
Set blades in highest position when mowing 
over rough ground.  
13.  Keep hands and feet away from rotating blades 
underneath deck.  
14.  DO NOT operate machine without entire grass 
catcher or guards in place. DO NOT point 
discharge at people, passing cars, windows or 
doors.  
15.  Slow down before turning. 
16.  Watch out for traffic when near or crossing 
roadways.  
17.  Move motion control levers SLOWLY to 
maintain control during speed and directional 
changes. 
18.  DO NOT operate engine in enclosed areas.  
Engine exhaust gases contain carbon 
monoxide, a deadly poison.  
MAINTENANCE  
1.  DO NOT store machine or fuel container inside 
where fumes may reach an open flame, spark or 
pilot light such as in a water heater, furnace, 
clothes dryer or other gas appliance. Allow 
engine to cool before storing machine in an 
enclosure. Store fuel container out of the reach 
of children in a well ventilated, unoccupied 
building.  
2.  Keep engine free of grass, leaves or excess grease 
to reduce fire hazard and engine overheating.  
3.  When draining fuel tank, drain fuel into an 
approved container outdoors and away from open 
flame.  
4.  Check brakes frequently (if equipped); adjust, 
repair or replace as needed. 
5.  Keep all bolts, nuts and screws properly tight. 
Check that all cotter pins are in proper position.  
6.  Always provide adequate ventilation when running 
engine. Exhaust gases contain carbon monoxide, 
an odorless and deadly poison.  
7.  Disconnect negative (black) cable from battery 
(if equipped) before performing maintenance or 
service. Cranking engine could cause injury.  
8.  DO NOT work under machine without safety 
blocks.  
9.  Service engine and make adjustments only 
when engine is stopped. Remove key. Remove 
spark plug wire(s) from spark plug(s) and 
secure wire(s) away from spark plug(s).  
10. 
DO NOT change engine governor speed 
settings or overspeed engine.  
11. Lubricate machine at intervals specified in 
manual to prevent controls from binding.  
12. Mower blades are sharp and can cut. Wrap the 
blades or wear heavy leather gloves and use 
CAUTION when handling them.  
13. DO NOT test for spark by grounding spark plug 
next to spark plug hole; spark plug could ignite 
gas exiting engine. 
14. 
Have machine serviced by an authorized 
SNAPPER dealer at least once a year and have 
the dealer install any new safety devices.  
15. Use only genuine SNAPPER replacement parts 
to assure that original standards are 
maintained.