Snapper FR215012 Benutzerhandbuch

 

 

5.  Hold the slotted end of the drive disc bolt with a 
screwdriver and remove the nut and internal tooth 
lock washer.  See Figure 4.17. 
 

 

6.  Lift the drive disc off the idler arm and remove 
worn belt. 
7.  Loop one end of new belt over engine pulley and 
insert the other end through slot in deck. See Figure 
4.17. 
8.  Loop the belt around the pulley on the bottom of 
the drive disc. 
9.  Reinstall drive disc and retaining hardware. 
10. Reinstall blade hub and cutter blade. Recom-mended 
torque for blade cap screw is 30 to 40 ft. lbs. 
11. 

Use a stiff wire, such as a coat hanger, with a 

hook fashioned on one end to pull the hooked end of 
the idler spring through the large hole in the right 
wheel bracket. See Figure 4.18. 
12. 

Reinstall the driven disc assembly. 

 
 
 
 
 

 

 

 

4.4.2.  Transmission Poly-V Belt Replacement 
1. Remove the driven disc. Refer to Section on 
“Replacing Driven Disc Rubber Ring” for procedure. 
2.  Note the routing of the old belt around the three 
pulleys before removing it.  See Figure 4.19. 
3.  Place new Poly-V Belt over end of hex shaft and 
onto driven pulley. 
4.  Work belt onto top of idler pulley. 
5. Twist belt sideways and pull it upward between 
the differential bracket and drive pulley and then 
down into the pulley groove.  Make sure the Poly-V 
Belt is above belt guide.  See Figure 4.19.