Snapper HZS15423KVE Benutzerhandbuch

 

IMPORTANT: This YARD CRUISER is equipped with 
hydrostatic drive. The forward, rearward and steering 
movement of the machine is controlled by a joystick lever. 
Joystick operations should be performed only from the 
operator’s position in the seat. A small movement of the 
joystick can cause the machine to move instantly. Move 
joystick very carefully and slowly.  
1.  Always move the joystick to the center position to “STOP” 
machine. IMPORTANT: To stop machine always return the 
joystick with hand assistance to the neutral position. Always 
engage parking brake when leaving operator’s seat. 
2.  Move the joystick forward to propel the machine forward.  
3. Move the joystick rearward to propel the machine 
backward. 
4.  Move the joystick to the right to rotate the front of the 
machine in circular motion to the right, as in turning around 
to go in a different direction. 
5.  Move the joystick to the left to rotate the front of the 
machine in circular motion to the left, as in turning around to 
go in a different direction. 

2.2.1.  ENGINE (ELECTRIC START) 
IMPORTANT: When the ignition key is turned to 
“START”, the engine will not turn over and will not start 
unless the Parking Brake is engaged and the Blade 
Switch is in the “Off” position. The operator should be 
in the seat. Start engine as follows: 
1.  Move joystick lever to (N) Neutral position. See 
Figure 2.5. 
2. Make certain the blade switch is in the “Off” 
position. See Figure 2.6. 
3.  Make certain the parking brake is engaged. See 
Figure 2.5. 
4. 

Open vent on fuel filler cap by turning 

counterclockwise.  IMPORTANT: Failure to open 
vent on the fuel filler cap can cause engine to stall. 
See Figure 2.3. 
5.  Turn fuel shut off valve to the open position. See 
Figure 2.3. 
6.  Move engine speed control to the choke position or 
pull choke control to choke position. See Figure 2.6. 
7. Turn key to the “START” position until engine 
starts. See Figure 2.5. NOTE:  If after 5 seconds of 
cranking the engine and it does not start, release the 
key. Attempt starting again after waiting for 
approximately 20 seconds. 
8.  After engine starts, move engine speed control to 
the “FAST” position or push choke control in to the 
“OFF” position, allow a brief warm-up until engine runs 
smooth.