Troy-Bilt Pro-Line Benutzerhandbuch

To prevent personal injury or property 

damage, do not start the engine until all assembly 

steps are complete and you have read and 

understand the safety and operating instructions.

3⁄8” open-end wrench
9⁄16” open-end wrench
7⁄8” open-end wrench
Scissors (to trim plastic ties)
Ruler
Small board (to tap plastic knob on lever)
Tire pressure gauge
Clean oil funnel
Clean, high-quality motor oil. Refer to the separate 

Engine Operator’s Manual for motor oil specifications and 

quantity.

3⁄8-16 x 1” Hex Hd. Screw (2)
Keyed Washer (1)
Wheel Gear Lever Knob (1)
Height Adjustment Flange Screw (1)
3⁄8” Flat Washer (2)
#10 Lockwasher (2)
3⁄8”-16 Nylock Lock Nut (2)
#10-32 x 1⁄2” Round Hd. Screw (2)
#10-32 Nut (2)
Cotter Pin (1)
Cable Tie (4)

Remove any cardboard inserts and packaging material 

from the carton. Remove any staples from the bottom of 

the carton and remove the carton.
Cut the large, plastic tie strap that secures the transmission 

tube to the shipping pallet. Leave the handlebars on top of 

the tiller to avoid damaging any cables.
The hardware pack is is inside the literature envelope. 

Check the contents with the list above.

•
•
•
•
•
•
•
•
•

•
•
•
•
•
•
•
•
•
•
•

1.

2.

3.

The tiller is heavy. You should not attempt to remove it 

from the shipping platform until instructed to do so in 

these steps.

Cut the large, plastic cable ties that secure the handlebar 

ends to the handlebar mounting tabs on the transmission 

top cover.
Gently lift the handlebar (do not overstretch the attached 

cable) and place the handlebar cross-brace in front of the 

curved height adjustment bracket. See Fig. 3-1.

4.

1.

2.

One Tiller 

•

One Handlebar Support

•

One Handlebar Assembly

•

One Hardware Pack

•

One Operator’s Manual

•

One Engine Operator’s Manual

•