Technicolor - Thomson 510 Benutzerhandbuch

1 SpeedTouch™ Installation

3EC 37891 AAAA TCZZA Ed. 01

1.3.2. Configuration Setup for other Operating 

Systems

Supported Systems

As the SpeedTouch™ is OS-independent in case of Ethernet connectivity, this configu-
ration setup can be used by any computer system.
Note: The following procedure may equally be used on MS Windows OSs (both 
Ethernet and USB if supported).

TCP/IP

Ensure that your Operating System has a valid TCP/IP configuration.
Configure every computer with a static Net10 private IP address, e.g. 10.0.0.1. Ensure, 
however, that you do NOT use the 10.0.0.138 IP address as this is the default IP address 
of the SpeedTouch™.
To ensure that IP connectivity exists, you can ping the SpeedTouch™.

Procedure

Step

Action

To ensure that the SpeedTouch™ is in its factory default state, reset the 
defaults. See chapter 

Open a web browser and browse to the SpeedTouch™'s default IP address 
10.0.0.138. See chapter 

 for 

more information.

As a result the SpeedTouch™ System Info web page appears.
Expand the Advanced Topics and click Setup open the SpeedTouch™ Setup 
web page.

In the Configuration table you can overview the current configuration settings 
active on the SpeedTouch™.
Click Browse to locate the configuration file on the CD-ROM or disk.

Note: If the path is known you can immediately enter it in the location input 
field.

Once the location of the appropriate configuration profile file is selected, click 
Upload.
The file will be uploaded to the SpeedTouch™ and immediately activated.

After the configuration is applied on the SpeedTouch™ some additional 
configuration of your computer system may be necessary.

Note: The required settings for your computer should be provided by your 
Service Provider, if applicable.

To check whether the activation of the uploaded configuration and the config-
uration of your computer system(s) - if required - was successful, you can 
browse to the SpeedTouch™ and check its current status.