Lowrance electronic HDS 8 Benutzerhandbuch

120

Troubleshooting

to 60ft or whatever depth you expect the fish to appear at.

This will maximize the screen resolution to show small ob-

jects larger on the screen. It is unlikely you will see average-

sized fish display as arches in a 100ft deep water column.

The boat must be moving at a slow trolling speed to see

fish arches. If the boat is motionless, fish stay in the cone

and show as horizontal lines on screen. This is especially

applicable to ice fishing.

A major cause of sonar problems is electrical noise. This

usually appears on the sonar’s display as random patterns

of dots or lines. In severe cases, it can completely cover the

screen with black dots, or cause the unit to operate errati-

cally, or not at all.

To eliminate or minimize the effects of electrical noise,

try to determine the cause. With the boat at rest in

the water, turn all electrical equipment on the boat

off including the engine. Turn on your sonar unit.

Sensitivity should be set at 70-75 percent. There should be

a steady bottom signal on the display. Now turn on each

piece of electrical equipment on the boat and view the effect

on the sonar’s display.

If you find noise interference is from an electrical instru-

ment, trolling motor, pump, or radio, you can usually reroute

the sonar unit’s power cable and transducer cable away

from the wiring causing the interference. VHF radio antenna

cables radiate noise when transmitting, so be sure to keep

the sonar’s wires away from it. You may need to route the

sonar unit’s power cable directly to the battery to isolate it

from other wiring on the boat.

If no noise displays on the sonar unit from electrical equip-

ment, then make sure everything except the sonar unit is

turned off, then start the engine. Increase the RPM with

the gearshift in neutral. If noise appears on the display, the

problem could be one of three things; spark plugs, alterna-

tor, or tachometer wiring. Try using resistor spark plugs, al-

ternator filters, or routing the sonar unit’s power cable away

from engine wiring to help eliminate noise problems. Make

sure to use the in-line fuse supplied with the unit when wir-

ing the power cable to the battery.

noise