Enterasys 6000 Betriebsanweisung
Configuring Cards and Protocols
4-3
Figure 4-2 LP Configuration Menu for FRX4000
[A],[B],[B]
from Main Menu
LP, Status, LP Type, and Line Interface Card 1 will always be as
shown above. Line Interface Card 2 will be read from the installed card
(if present).
shown above. Line Interface Card 2 will be read from the installed card
(if present).
To add or remove a protocol:
1. Press the letter corresponding to the protocol number. The protocol in the
Configured
column will change to the next available one. (See Table 4-1.)
Rebooting will clear all connections on this node. However, the
node must be rebooted to implement the change.
node must be rebooted to implement the change.
2. When finished configuring this screen, press
[F10]
.
3. When asked:
Reboot the Node?
, press
[Y]
. This will reboot the device and restart
the FRX4000 software.
Node N ame= nod exyz
Line Processor C onfiguration
*
*
LP: 0
*
S tatus: I nstalled
*
Memory Configuration: 8 Meg
*
LP Typ e: R LP
*
Line I nterface C ard 1: UN IVER SAL
*
Line I nterface C ard 2: V.35
Configured
Loaded
A
Protocol 1:
X.25
X.25
B
Protocol 2:
FR L
FR L
C
Protocol 3:
Asyn c
Asyn c
D
Protocol 4:
SDLC
SDLC
E
Protocol 5:
IP
IP
F
Protocol 6:
None
G Protocol 7:
None
H Protocol 8:
None
I
Protocol 9:
None
Option: