TomTom 510 Verweisanleitung

RDS-

TMC Re-

ceiver 

Guide

This guide explains how to set up the TomTom RDS-TMC 

Traffic Receiver, for receiving traffic information to help 

improve your journey times and travel planning.

Before connecting the RDS-TMC Traffic Receiver for the first 

time, make sure your TomTom device is switched off.

1. Attach the TomTom device to the Windscreen Holder.
2. Plug the TMC receiver into your TomTom device or the 

Windscreen Mount, depending on your product

3. Position the TomTom device at the bottom left corner of 

the car windscreen.

4. Press the transparent suction cup at the tip of the 

antenna firmly against the upper left corner of the car 

windscreen

5. Press the second transparent suction cup firmly against 

the bottom left corner of your windscreen.

6. Place the egg shaped receiver with the black suction cup 

on the windscreen at any place convenient. Avoid 

putting too much tension on the cables.
The Traffic bar is shown in the Driving View and your 

TomTom device searches for a radio station that carries 

RDS-TMC information.

While your TomTom device is searching for a radio station, 

the following symbols are shown on the top of the Traffic 

bar:

If you want to tune to a particular radio station, you can enter 

the frequency as follows:
1. Tap the Traffic bar in the Driving View.
2. Tap Tune RDS-TMC.
3. Enter the frequency of the radio station.
4. Tap Done.
Your TomTom device looks for the radio station. If it does 

not find the station you requested, it will search for the next 

available station.

Your TomTom device is looking for a 

radio station.

Your TomTom device has found a 

radio station and is checking if the 

radio station carries RDS-TMC 

information.

Your TomTom device is tuned to a 

radio station and receives RDS-TMC 

information when available.

RDS-TMCReceiverSupportGuide.fm  Page 1  Friday, July 13, 2007  12:08 PM