Enterasys csx400 Betriebsanweisung

Local Management User’s Guide

1-15

The SNMP Traps screen provides display and configuration access to the table of 

IP addresses used for trap destinations and associated community names.

The Flash Download screen lets you download a firmware image from a 

TFTP server to the HSIM or CyberSWITCH.

The WAN Setup menu item accesses two other screens that provide WAN 

physical configuration and WAN Interface configuration access to enable a WAN link to be set up. 

The Bridge Setup screen lets you select a Spanning Tree protocol and enable/

disable switch ports.

The Router Setup screen accesses two other screens that provide general IP or 

IPX routing configuration and allow you to enable or disable the Routing Information Protocol 
(RIP) and the Service Advertising Protocol (SAP) features.

The System Level screen displays the physical address (MAC address) of the HSIM or 
CyberSWITCH and allows you to set the following parameters:

System Date

System Time

Host IP Address

Subnet Mask

Physical Address

Default Gateway

Default Interface

If you have a WPIM-T1, WPIM-DDS, or a WPIM-HDSL installed in your HSIM or 
CyberSWITCH, refer to the WAN Setup section of this chapter for configuration 
information. For all other WPIMs, refer to your specific WPIM(s) Local Management 
Guide or the Appendix for information on configuring the WPIM for a Wide Area 
Network Interface

.