Enterasys csx400 Betriebsanweisung
Local Management
1-20
Local Management User’s Guide
2.
Enter the IP address of the Default Gateway using DDN format.
For example: 168.192.79.121
3.
Press ENTER. If the Default Gateway address entered was a valid format, the cursor returns to
the beginning of the Default Gateway field. If the entry was not valid, the Event Message field
displays “INVALID DEFAULT GATEWAY OR FORMAT ENTERED”. Local Management
does not alter the current value and refreshes the Default Gateway field with the previous value.
the beginning of the Default Gateway field. If the entry was not valid, the Event Message field
displays “INVALID DEFAULT GATEWAY OR FORMAT ENTERED”. Local Management
does not alter the current value and refreshes the Default Gateway field with the previous value.
4.
Use the arrow keys to highlight the SAVE command field.
5.
Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
Setting the Default Interface
To set the default interface, perform the following steps:
1.
Use the arrow keys to highlight the Default Interface field.
2.
Enter the interface number for the Default Gateway in this field.
3.
Press ENTER. If the interface entered was a valid format, the cursor returns to the beginning of
the Subnet Mask field. If the entry was not valid, the Event Message field displays
“PERMISSIBLE RANGE: 1...X”. Local Management does not alter the current value and
refreshes the Default Interface field with the previous value.
the Subnet Mask field. If the entry was not valid, the Event Message field displays
“PERMISSIBLE RANGE: 1...X”. Local Management does not alter the current value and
refreshes the Default Interface field with the previous value.
4.
Use the arrow keys to highlight the SAVE command field.
5.
Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.
NOTE
The default gateway is intended for bridging only mode. For routing use a default route
entry in your routing table.
entry in your routing table.
NOTE
Both the default gateway and default interface must be changed or an error results. To
return to the default state, select NONE DEFINED for both the default gateway and
default interface selections.
return to the default state, select NONE DEFINED for both the default gateway and
default interface selections.
The default gateway is intended for bridging only mode. For routing use a default route
entry in your routing table.
entry in your routing table.