Enterasys 2200 Betriebsanweisung
Supported Features and Functions
B-2
About IGMP
B.2
SUPPORTED FEATURES AND FUNCTIONS
The following lists the features and functions supported when using IGMP:
•
Runs only when the switch is operating in the 802.1Q mode.
•
Supports multiple multicast and non-multicast routers on the same VLAN.
•
Supports stand alone multicast servers only if a router is present on the network.
•
Multicast forwarding rate is dependent on the number of ports the multicast stream is forwarded
to. More ports degrade the performance.
to. More ports degrade the performance.
•
Supports IGMP version 1 and 2 only. Default is version 2.
•
Ports that are directly connected to routers are discovered dynamically through snooping for
routing protocols.
routing protocols.
•
IGMP is enabled or disabled per VLAN, and not per port.
•
IGMP will run with GMRP, however, the IGMP does have higher priority then GMRP.
•
The switch does not act as the querier. A router is required for IGMP on the switch to function.
•
The switch will “snoop” on all incoming multicast addresses to detect query responses, as well
as queries. Query responses are sent to the multicast address detected in the stream from the host
requesting to receive queries. The frame is an IP frame of protocol type 2. If the frame is a
response frame, IGMP will take the multicast address and VLAN ID, and program a filter on the
receive port. The response is then forwarded out upstream ports so that the router will receive it.
Ports that receive queries are marked as upstream ports. It is assumed a router exists somewhere
off this port, and responses are sent here. If the switch detects a router protocol on a port, that
port is also marked as a router port. This keeps the switch from blocking traffic to other routers.
as queries. Query responses are sent to the multicast address detected in the stream from the host
requesting to receive queries. The frame is an IP frame of protocol type 2. If the frame is a
response frame, IGMP will take the multicast address and VLAN ID, and program a filter on the
receive port. The response is then forwarded out upstream ports so that the router will receive it.
Ports that receive queries are marked as upstream ports. It is assumed a router exists somewhere
off this port, and responses are sent here. If the switch detects a router protocol on a port, that
port is also marked as a router port. This keeps the switch from blocking traffic to other routers.