Sanyo PDG-DHT8000L Betriebsanweisung
65
Turn off the projector, press the Main On/Off Switch to
Off and unplug the AC power cord from the AC outlet.
First, clean up the dust on the projector and around the
air vents.
1
2
2
Open the filter cover. (See the right figure.)
3
Put the new one back into the position and close
the filter cover. Make sure that the filter cartridge is
properly and fully inserted.
5
CAUTION
- Do not put anything into the air vents. Doing so
may result in malfunction of the projector.
- In the event of installation/replacement of the
filter cartridge, turn off the projector, press the
Main On/Off Switch to Off and unplug the AC
power cord from the AC outlet.
4
Reset the filter counter and the scroll counter (p.66).
6
Replacing the Filter Cartridge
Pull out the filter cartridge. When taking out
the filter cartridge, put your finger on the filter
cartridge’s tab and then pull.
RECOMMENDATION
We recommend avoiding dusty/smoky environments when
operating the projector . Usage in these environments may
cause a poor image quality .
When using the projector under dusty or smoky conditions, dust
may accumulate on a lens or optical elements inside the projector.
Such condition may degrade the quality of the projected image.
When the symptoms above are noticed, contact your authorized
dealer or service center for proper cleaning.
ORDER REPLACEMENT FILTER CARTRIDGE
Replacement filter cartridge can be ordered through your
dealer. When ordering, give the following information to the
dealer.
l
Model No . of your projector
PDG-DHT8000L
l
Replacement Filter Cartridge
Type No . : POA-FIL-090
(Service Parts Code: 610 50 7811)
Connect the AC power cord to the projector and turn
on the projector.
7
Maintenance and Care
Filter cover
Filter cartridge
Tab