Sanyo PLC-EF60A Benutzeranleitung

Before calling your dealer or service center for assistance, check the items below once again.

– Make sure you have properly connected the projector to peripheral equipment as described on pages 22~24. 
– Make sure all equipment is connected to AC outlet and the power is turned on.
– When you operate the projector with a computer and it does not project an image, restart the computer.  

– Solutions

– Plug the power cord of the projector into the AC outlet.
– Make sure the Main On/Off switch is on.
– See if the LAMP indicator lights red.
– Wait 90 seconds after the projector is turned OFF when turning the 

projector back on. The projector can be turned on after the READY indicator 
turns green. (

☞

“Turning Off the Projector” on page 28)

– Check the WARNING TEMP. indicator.  If the WARNING TEMP. indicator 

lights red, the projector cannot be turned on.  
(

☞

“Warning Temp Indicator” on page 60)

– Check the projection lamp.  (

☞

p.62)

– Unlock Key lock for the projector in the Setting Menu. (

☞

p.54)

– Check if the air filter is fully installed and the filter cover is completely 

closed. (

☞

p.61)

– Adjust focus of the projector. (

☞

p.29)

– Check the projection lens to see if it needs cleaning. (

☞

p.64)

– Moving the projector from a cool to a warm place may result in moisture 

condensation on the projection lens. In such cases, leave the projector 
OFF and wait until condensation disappears.

– Check the connection between your computer or video equipment 

and the projector. (

☞

p.22~24)

– See if the input signal is correctly output from your computer. Some laptop 

computers may need to change the setting for monitor output when 
connecting to a projector. See your computer’s instruction manual for the
setting. 

– It takes about 20 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video 

equipment. (

☞

p.38~39)

– Select correct input source once again through menu operation.

(

☞

p.36~37)

– Make sure the temperature is not out of the specified Operating 

Temperature (5°C ~ 35°C).

– Check if the shutter is closed.  (

☞

p.29)  

– Adjust Brightness and Contrast in the Image adjust menu. (

☞

p.44)

– Check the Shutter level. (

☞

p.53)

– Check each lamp condition and the LAMP 1/2 REPLACE indicators. 

(

☞

p.62, 67)

– Check the Ceiling/Rear item. (

☞

“Screen Setting” on page 48.)

– Check the Ceiling item. (

☞

“Screen Setting” on page 48.)