Sanyo PLC-XL50 Betriebsanweisung

When  the  projection  lamp  of  the  projector  reaches  its  end  of 

life,  the  Lamp  replacement  icon  appears  on  the  screen  and 

LAMP REPLACE indicator lights yellow. Replace the lamp with 

a  new  one  promptly. The  timing  when  the  LAMP  REPLACE 

indicator should light is depending on the lamp mode.

Follow these steps to replace the lamp.

Lamp

Replacement lamp can be ordered through your dealer.  When ordering a projection lamp, give the following 

information to the dealer.

●

 

●

 

 

     

 

 

 

 

       

   (Service Parts No. 610 337 9937)

For  continued  safety,  replace  with  a  lamp  of  the 

same  type.  Do  not  drop  a  lamp  or  touch  a  glass 

bulb! The glass can shatter and may cause injury.

Allow  a  projector  to  cool  for  at  least  45  minutes 

before you open the Lamp cover. The inside of the 

projector can become very hot.

Screw

Turn  off  the  projector  and  unplug  the AC  power  cord. 

Let the projector cool for at least 45 minutes.

Loosen  the  two  (2)  screws  that  secure  the  lamp.  Lift 

the lamp out of the projector by using the handle.

Replace the lamp with a new one and secure the two 

(2)  screws.  Make  sure  that  the  lamp  is  set  properly. 

Close the lamp cover and secure the screw.

Connect  the AC  power  cord  to  the  projector  and  turn 

on the projector.

See “Lamp Replacement Counter” on the next page.

Handle

Screw

WARNING: 

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER

Lamp replacement icon

✔

✔

Lamp Cover

Screw

Remove the screw from the lamp cover and open the 

cover.