GE js998skss Installationsanweisungen

• Check to make sure the circuit breaker is

closed (RESET) or the circuit fuses are
replaced.

• Be sure power is in service to the building.

• Check to be sure that all packing materials

and tape on metal panel (if applicable)
under control knobs and drawer have been
removed.

• Push down and turn any one of the four

surface knobs to MED setting to observe
that the element glows within 15 seconds.
Turn the knob off when glow is detected. 
If the glow is not detected within the time
limit, recheck the range wiring connections.
If change is required, retest again. If no
change is required, have building wiring
checked for proper connections and voltage.

• Turn on the power to the oven. (Refer to

your Owner’s Manual). Verify that the bake
and broil functions make the oven hot by
feeling heat coming off the elements within
20 seconds.

Place the drawer rail on the guides.

Push the drawer in until it stops.

Lift the front of the drawer and push in
until the stops clear the guides.

Lower the front of the drawer and push
in until it closes.

Remove and replace, making sure the
power cord is not obstructing the drawer
and/or the rail is in the guide.

Remove and replace, making sure the
rail is in the guide.

Stop

Drawer does 
not close
completely

Power cord may be

obstructing drawer in

this area

Drawer front

panel tipped

away from

body side

Rear drawer support

is resting on top of

guide rail

Rear drawer
support is on 
top of guide rail
on the high side

Drawer front panel 
tipped to one side