DEI tvm300 Installationsanweisungen

© 2001 Directed Electronics, Inc.  

Installing the TVM300 requires working
on the PC board of the MCB1000. Only
a MECP Certified technician should per-
form this installation.

1.

Disconnect all power wires and
cables from the MCB1000 before
beginning this installation. Failure
to do so could result in fire or
damage to the MCB1000 circuitry.

2.

Remove the Philips head screws at
both ends of the MCB1000 module
and remove the cover.

3.

Locate the open rectangular area
in the corner of the PC board. This
is the mounting location. Note
the location of the female 20-pin
connector.

4.

Position the TVM300 over the
mounting location and check align-
ment of the antenna connector slot
in the case, the 20-pin connector,
and the two machine screw mounts.

5.

Carefully align the TVM300 to the
20-pin connector and press down
firmly until the TVM300 mounting
brackets align with the machine
screw mounts.

6.

Secure the TVM300 to the circuit
board with the supplied machine
screws.

7.

Verify that the TVM300 is secured
and reinstall the MCB1000 module
cover.

8.

Complete the installation/rein-
stallation of the MCB1000. Verify
all connections are correct
according to the instructions 

9.

Be sure to attach the TV antenna,
then test the system operation.

N84101 12-01