Alcatel-Lucent 6850-48 Verweisanleitung
IPv6 Commands
OmniSwitch CLI Reference Guide
September 2009
page 33-9
ipv6 address local-unicast
Creates a IPv6 local unicast address using the configured global ID.
ipv6 address local-unicast [global-id globalID] [subnet-id subnetID] {interface-id interfaceID | eui-64}
[prefix-length prefixLength] {if-name | loopback}
[prefix-length prefixLength] {if-name | loopback}
[no] ipv6 address local-unicast [global-id globalID] [subnet-id subnetID] {interface-id interfaceID |
eui-64} [prefix-length prefixLength] {if-name | loopback}
eui-64} [prefix-length prefixLength] {if-name | loopback}
Syntax Definitions
globalID A 5-byte global ID value specified in the form hh:hhhh:hhhh.
subnetID A 2-byte Subnet ID specified in the form 0xhhhh. The valid range is
0x0000-0xffff or 0-65535.
interfaceID An interface identifier specified in the form hhhh:hhhh:hhhh:hhhh.
eui-64 Automatically-generated EUI-64 value to be used for interface identfier.
prefixLength The number of bits that are significant in the IPv6 address (mask). The
valid range is 0-128; however, the default value should rarely be over-
ridden.
ridden.
if-name The name assigned to the interface.
loopback The loopback for the loopback interface.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of this command to delete the local unicast address. However, addresses are normally
deleted using the
command.
• If the global ID value is not explicitly specified, the default global ID set by the
command is used.
• If the global ID value is explicitly configured using the
command, the
address’ global ID will not be changed if the
command is executed.
• The use of a double-colon abbreviation for the interface identifier similar to that used for full IPv6
addresses is allowed.
parameter
default
prefixLength
64