Alcatel-Lucent 6850-48 Verweisanleitung
RIP Commands
page 37-2
OmniSwitch CLI Reference Guide
September 2009
ip load rip
Loads RIP into memory. When the switch is initially configured, you must load RIP into memory before it
can be enabled.
can be enabled.
ip load rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• In simple networks where only IP forwarding is required, you may not want to use RIP. If you are not
using RIP, it is best not to load it to save switch resources.
• To remove RIP from switch memory, you must manually edit the boot.cfg file. The boot.cfg file is an
ASCII text-based file that controls many of the switch parameters. Open the file and delete all refer-
ences to RIP. You must reboot the switch when this is complete.
ences to RIP. You must reboot the switch when this is complete.
• Use the
command to enable RIP on the switch.
Examples
-> ip load rip
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaDrcTmConfig
alaDrcTmIPRipStatus
Enables/disables RIP routing on the switch.
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
forced hold-down timer).