Fujitsu dl-3750 Benutzerhandbuch

USING SETUP MODE

User's Manual

5-39

Before adjusting a print position, you should carefully measure the amount

of adjustment required for any paper that demands precise print registration.

To adjust a print position, make sure that continuous forms paper is loaded.

The following example shows how to adjust the top-of-form setting for

continuous forms.

Press the TEAR OFF button and the ONLINE button simultaneously

until the printer beeps.  Wait for the printer to stop printing and

check that the following <<FUNCTION>> menu is printed:

<<FUNCTION>>

  SAVE&END  MENU1  MENU2  HARDWRE  ADJUST  CONFIG  DEFAULT  LIST   SELF-TST  HEX-DUMP

  V-ALMNT

Repeatedly press the LOAD button or the LF/FF button to position

the red cursor under ADJUST.  Press the MENU button or the TEAR

OFF button to select the ADJUST function and print the following

<CNT-ORG> options:

<CNT-ORG>

 1/6IN   1.8/6IN   2/6IN   3/6IN   4/6IN   5/6IN   6/6IN   7/6IN   8/6IN   9/6IN

 10/6IN  11/6IN   ....

Press the LOAD button or the LF/FF button to move the cursor to the

required option.  Press the MENU button to select the option and

print the <CNTFINE> item.  If necessary, fine-tune the top-of-form

position now.  Otherwise, go to step 4.

Press the ONLINE button to exit the ADJUST function and reprint

the <<FUNCTION>> menu.