Fujitsu dl-3750 Benutzerhandbuch

SETTING UP

User's Manual

2-13

At this point, load paper and run the printer self-test.  The self-test checks

printer performance and print quality before you connect the printer to the

computer.  Use either single sheets or continuous forms (see Chapter 3).  This

section describes the self-test procedure using single sheets.

To print the self-test, use paper wider than 215.9 mm (8.5 inches) and set the

left paper guide all the way to the right to avoid clipping the test pattern.

Standard letter or A4 size paper can be used lengthwise (portrait mode).

Before loading paper, make sure that the printer is on.  Then, proceed as

follows:

1. Make sure that the paper thickness lever (located on the top right of

the printer) is at position 1.  Make sure that the paper select lever

(located on the top left of the printer) is set to the front, as shown

below.