Fujitsu dl-3750 Benutzerhandbuch

User's Manual

PAPER HANDLING

3-13

Quick

Reference

Introduc-

tion

Setting Up

Paper

Handling

Printing

Setup Mode

NOTE

When you use continuous forms, make sure that the edges of both left and

right paper guides do not touch the paper.

Slide both paper guides flush against the ends of both sides.

Adjusting the TEAR OFF position

When the TEAR OFF button is used to advance the paper to cut it, the paper

cut position and the perforation position may not match. In such cases, adjust

their positions by using the following procedure.

Adjustment procedure

1. Use the TEAR OFF button to advance the paper to its cut position.

(Keep holding down the TEAR OFF button.)

2. While holding down the TEAR OFF button, adjust the cut position by

using the LF/FF button or LOAD button.

LF/FF button: Pressing this button once extends the paper feed

amount by 1/180 inches.

LOAD button: Pressing this button once reduces the paper feed

amount by 1/180 inches.

- The adjustment range is plus or minus 63/180 inches

(approximately 9 mm). When it is exceeded, an alarm beeps.

3. When the cut position is adjusted, release the TEAR OFF button.

The paper feed amount at the end of the adjustment is stored as the

amount by which the paper will be fed when the TEAR OFF button is

pressed.

Good

Unacceptable

Right paper
guide

Left paper
guide

Continuous
form

Cut sheet
stand