Fujitsu fi-5530C2 Installationsanweisungen

Fujitsu USB Scanner Installation Procedures 

Windows 98SE\ME\2000\XP\Vista 

 

Rev082708A  

 

Page 1 of 1 

If you are installing the following models by means of the factory provided USB interface then 
please use this document. 
 
Fi-5530C2 

 
Hardware requirements. 
 
You will need a PC system that meets our recommended specifications.  For recommended PC 
system specifications please reference the 

need your Operating System Disk. 
 
 
Step A: Installing the drivers from the Setup CD. 
 
To begin it is recommended that you install the drivers first before connecting the scanner. 
 

Installing the STI-Twain driver. 
 
1.  Insert the Scanner Setup CD into your CD Rom. 
2.  Next please complete the pre-registration box when it appears and click the submit 

button. 

3.  Afterwards close your browser and click the Install Products button on the Scanner 

Setup Menu. 

4.  On the next screen click on Twain Driver and you may be presented with the option 

to install the Error Recovery Guide. 

5.  After you have installed the Error Recovery Guide (or not) follow the prompts to 

complete the twain driver installation.   

6.  Do not reboot at this time! 
 
Installing the ISIS driver. 
 
7.  Next go back to the Scanner Setup Menu and click on ISIS Driver. 
8.  If you didn’t install the Error Recovery Guide during the Twain driver installation you 

will be asked again.  Proceed and follow the prompts to complete the ISIS driver 
installation.   

9.  Do not reboot at this time! 

 

Installing ScandAll Pro. 
 
10. Back to the Scanner Setup Menu and click on ScandAll Pro. 
11. The ScandAll Pro installation wizard will appear.  Click next and follow the prompts to 

complete the installation. 

12. Once all of the above is completed then remove the Scanner Setup CD, Reboot 

your system, and go to Step C.