Printronix P5000 Benutzerhandbuch
Removal and Installation
125
The shipping kit for this printer includes 220 ohm pull-up and 330 ohm pull-
down alternate terminating resistors. If you install the 220 ohm pull-up
resistor, you must also install the 330 ohm pull-down resistor. Table 13 lists
the three terminating resistor configurations you can install:
down alternate terminating resistors. If you install the 220 ohm pull-up
resistor, you must also install the 330 ohm pull-down resistor. Table 13 lists
the three terminating resistor configurations you can install:
Removal and Installation
IMPORTANT
This is an involved maintenance procedure; only a trained technician
should perform this procedure.
should perform this procedure.
The procedure for removing and installing terminating resistors is provided in
the Maintenance Manual.
the Maintenance Manual.
Table 13. Terminating Resistor Configurations
Configuration
Pull-Up (RP1)
Pull-Down (RP2)
Factory Default
470 ohm
1K ohm
Alternate 1
220 ohm
330 ohm
Alternate 2
1K ohm
none