Printronix P5000 Anleitung Für Quick Setup
Chapter 1
Basic Operating Procedures
56
3.
If necessary, clean the interior of the printer. (See page 81.)
4.
Install the new ribbon:
a.
With the ribbon to the outside, place the full spool on the right hub.
Press down on the spool until the hub latch snaps in place.
b.
Thread the ribbon around the ribbon guide and along the ribbon
path. Refer to the ribbon path diagram on the shuttle cover. Be
sure to thread the ribbon between the hammer bank cover and
the ribbon mask.
c.
Place the empty spool on the left hub. Press down on the spool
until the hub latch snaps into place.
d.
Hand-turn the left spool to make sure the ribbon tracks correctly in
the path and ribbon guides.
Hub Latch
Hammer Bank Cover
Ribbon
Mask
Ribbon Guide
Caution
The ribbon must not be twisted. A twisted ribbon can lower print quality,
shorten ribbon life, or cause paper jams.
shorten ribbon life, or cause paper jams.