Printronix l7032 Benutzerhandbuch

5.6.4 Remove the Transfer Charger Unit

1. Grasp the transfer charger unit by its handle nd pull it straight out of the printer. See Figure

5-12.

Figure 5-12. Removing the Transfer Charger Unit

2. Place the transfer charger unit on the towel or sheet you prepared for it.

5.6.5 Remove the Fuser Unit

1. Turn the fuser latch counterclockwise slightly until it releases the fuser drawer on the left

side of the printer.

2. Make sure that the fuser drawer is all the way out of the printer. The drawer should be

latched open.

Caution: If the printer has been in operation, the fuser unit may be very hot.

3. Unplug the two electrical connectors attached to the fuser drawer as follows:

• Unplug the smaller connector on top by pressing the clip on the top of the connector and

pulling it firmly away from the printer.

• Unplug the larger connector by pressing the two clips, one on each side, and pulling the

connector firmly away from the printer.

See Figure 5-13.