Printronix P7000 Verweishandbuch
94
Chapter
3
Configuring The LQ-1600K Emulation With Control Codes
Select Vertical Printing (for Hanzi BIG5 Printer only)
ASCII Code SSCC +
n
Hex Code
SSCC 2B
n
Dec Code
SSCC 43
n
Purpose
The character is printed with different degrees of rotation in the
counter-clockwise direction under DBCS mode.
counter-clockwise direction under DBCS mode.
n = 0 or 48
90 degrees rotation
n = 1 or 49
180 degree rotation
n = 2 or 50
270 degree rotation
n = 3 or 51
rotate DBCS full width character 90 degrees
n = 4 or 52
normal character
Where:
n = 0, 1, 2, 3, 4, 48, 49, 50, 51, 52
n = 0, 1, 2, 3, 4, 48, 49, 50, 51, 52
Comment
The default value is
n = 4, normal character.
NOTE: This command is only supported in the Hanzi TW printer.
Select Vertical Tab Channel
ASCII Code ESC /
c
Hex Code
1B 2F
c
Dec Code
27 47
c
Purpose
Selects a vertical tab channel set by ESC b.
Where:
c = 0 through 7
c = 0 through 7
Comment
Subsequent VT (hex 0B) commands use tab table specified by
c. If no tab table is selected, table 0 is used.
c. If no tab table is selected, table 0 is used.
Set 0-dot Intercharacter Spacing of DBCS Characters
ASCII Code SUB Q
Hex Code
1A 51
Dec Code
26 81
Purpose
Sets 0-dot intercharacter spacing of DBCS characters.
Comment
This command affects the front panel setting of “DBCS CPI.”