Printronix SL5000e Benutzerhandbuch

Loading Fanfold Media

13. Close the printhead by pressing down on both sides of the pivoting deck

and rotating the deck lock lever fully counterclockwise. This locks the
pivoting deck and printhead assembly into the printing position.

IMPORTANT

Ensure the pivoting deck is down and locked before attempting to
advance media or print. Failure to do so will cause the “PRINTHEAD UP”
fault message to display.

14. Verify that Print Mode submenu is set for the media type installed (direct

or transfer). The Print Mode submenu is located in the QUICK SETUP
menu. See “Main Menu” on page 92 for more information. Also, if thermal
transfer media is installed, see “Loading Ribbon” on page 53.

15. Verify the printhead pressure is properly set. See “Printhead Pressure

Adjustment” on page 66.

16. Verify the pressure blocks are properly positioned. See “Printhead

Pressure Block Adjustments” on page 67.

17. Verify the Gap/Mark Sensor selection matches the type of media

installed. See “Sensing Different Media Types” on page 73.

Deck Lock
Lever

Pivoting
Deck