Printronix SL5000e Benutzerhandbuch
100
Chapter
3
QUICK SETUP
QUICK SETUP
QUICK SETUP
Validator Funct.
(7)
Notes:
* = Factory Default
1
Maximum value depends on the printer model width
(4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL) when
Admin User is enabled.
Admin User is enabled.
3
Based on the current value setting for the Label
Length (in QUICK SETUP), up to a maximum of
12.80 inches.
12.80 inches.
4
Maximum value depends on the width of the printer
model (see Appendix A, “Specifications”).
5
Maximum value depends on model width and size of
DRAM installed (see Appendix A, “Specifications”).
6
Gap/Mark Sensor and Paper Out Sensor work in
conjunction, as shown in Table 6 on page 134. If you
change the Gap/Mark Sensor or Paper Out Sensor,
you must recalibrate the media.
change the Gap/Mark Sensor or Paper Out Sensor,
you must recalibrate the media.
7
Appears only if a validator is installed.
Print Intensity
6 ips*
2-10 ips
(1)
Print Speed
Print Mode
Paper Feed Shift
Label Width
Label Length
Orientation
Transfer*
Direct
4.1, 6.6, or 8.5 inches*
(2)(4)
Portrait*
Landscape
Inv. Portrait
Inv. Landscape
-3*
-15 to 15
00.1 to 8.5 inches
(4)
0.00 inches*
(2)
4 or 6 inches*
(2)(4)
00.1 to 99.0 inches
(5)
-0.50 to
X
inches
(3)
Run Calibrate
Auto Calibrate
1*
1-8
Factory*
1-8
Save Config.
Power-Up Config.
Ver Image Shift
Hor Image Shift
0.00 inches*
(2)
-1.00 to 1.00 inches
0.00 inches*
(2)
-1.00 to
X
inches
(3)
Enable*
Disable
Tear-Off Strip*
Tear-Off
Peel-Off
Cut
Media Handling
Continuous
Gap/Mark Sensor
(6)
Disable*
Mark
Gap
Advanced Notch
Advanced Gap