Netopia r6100 Verweisanleitung

10-4 User’s Reference Guide

The filter set you select will be applied to the Ethernet hub inter face.

To remove the filter set from the Ethernet hub inter face, select Remove Filter Set and press Return. The
filter set will be disconnected from the LAN inter face.

Note: Removing the filter set from the LAN does not delete the filter set. It is still available to be reassociated
with the same or another inter face, or modified fur ther.

For more information on filters and filter sets, see

“Security” on page 16-1

■

Select Static Routes to manually configure IP routes. See the section

“Static routes,”

below.

■

Select Network Address Translation to configure advanced MultiNAT features. See

“Multiple Network

Address Translation (MultiNAT)” on page 11-1

■

If you select IP Address Serving you will be taken to the IP Address Ser ving screen (see

“IP address

ser ving” on page 10-11

). Since no two hosts can use the same IP address at the same time, make sure

that the addresses distributed by the Netopia R6000 Series and those that are manually configured are
not the same. Each method of distribution must have its own exclusive range of addresses to draw from.

■

If you select Filter Sets you will be taken directly to the screen for configuring IP packet filters. For
information see

“About Filters and Filter Sets,” beginning on page 16-9

Caution! LAN filter sets only filter or block traffic between multiple subnets. They do not filter or block traffic
originating from the external Internet.

IP Setup

Ethernet IP Address: 192.168.1.1
Ethernet Subnet Mask: 255.255.255.0
Define Additional Subnets...