Netopia r6100 Verweisanleitung
Dial Backup 9-7
lished and the router switches back to it from the backup mode.
■
You can toggle Auto-Recovery on loss of Layer 2 to Yes or No (the default). This setting determines
whether the router should tr y to Auto-Recover when the backup is invoked because of a Layer 2 loss,
for example, a no valid Connection Profile. (Layer 1 is still available, and this is what recover y checks.)
Use this setting with caution. Setting it to Yes may induce alternate switching between Backup and
Recover y Mode. This field will determine the recover y behavior of a Manual backup and Ping failure
backup. These two failures are treated as Layer 2 failures.
whether the router should tr y to Auto-Recover when the backup is invoked because of a Layer 2 loss,
for example, a no valid Connection Profile. (Layer 1 is still available, and this is what recover y checks.)
Use this setting with caution. Setting it to Yes may induce alternate switching between Backup and
Recover y Mode. This field will determine the recover y behavior of a Manual backup and Ping failure
backup. These two failures are treated as Layer 2 failures.
Note: Backup and Recover y have resolutions of five seconds. This is how often the router evaluates the state
of the connections and makes decisions.
of the connections and makes decisions.
■
Data Link Encapsulation is set to Async PPP. This field is not editable.
IP Setup screen
The IP Setup screen now permits entr y of a backup IP gateway address. This field is always visible, even if the
Default IP Gateway field is not filled out, as in the case of a DHCP-acquired IP address and default gateway on
the primar y WAN inter face.
Default IP Gateway field is not filled out, as in the case of a DHCP-acquired IP address and default gateway on
the primar y WAN inter face.
For more information on IP Setup see
IP Setup
Ethernet IP Address: 192.168.1.1
Ethernet Subnet Mask: 255.255.255.0
Define Additional Subnets...
Ethernet Subnet Mask: 255.255.255.0
Define Additional Subnets...
Default IP Gateway: 0.0.0.0
Backup IP Gateway: 0.0.0.0
Primary Domain Name Server: 0.0.0.0
Secondary Domain Name Server: 0.0.0.0
Domain Name:
Backup IP Gateway: 0.0.0.0
Primary Domain Name Server: 0.0.0.0
Secondary Domain Name Server: 0.0.0.0
Domain Name:
Receive RIP: Both
Transmit RIP: Off
Static Routes...
Transmit RIP: Off
Static Routes...
IP Address Serving...
Network Address Translation (NAT)...
Filter Sets...
Network Address Translation (NAT)...
Filter Sets...
Set up the basic IP attributes of your Netopia in this screen.