Quantum DAT 160 Betriebsanweisung
Chapter 2 Installing Internal Tape Drives
Attach Power and SCSI Cables
Quantum DAT 160 User’s Guide
20
Therefore, assuming the HBA is the first device on the bus, you should
check that the second terminator is placed after the last device (see
Checking SCSI
Termination
Termination
2
The internal tape drive does not provide SCSI termination.
shows two examples of terminating the internal tape drives.
If the drive is the only SCSI device on the bus:
If the drive is the only SCSI device on the bus:
1
Attach it to the next-to-last connector on the SCSI chain.
2
Attach a multi-mode terminator to the last connector in the chain.
This terminator typically is a small, rectangular plastic block that is
marked SCSI Terminator and attaches to the cable.
Figure 12 Two SCSI
Termination Examples for the
Internal Tape Drives
Termination Examples for the
Internal Tape Drives
SCSI terminator
Tape drive
(no termination)
(no termination)
SCSI device
(termination
disabled)
(termination
disabled)
SCSI controller
(termination
enabled)
(termination
enabled)
SCSI device
(termination
enabled)
(termination
enabled)
Tape drive
(no termination)
(no termination)
SCSI controller
(termination
enabled)
(termination
enabled)