Quantum DAT 160 Betriebsanweisung
Chapter 3 Installing External Tape Drives
Connecting the SCSI Tape Drive
Quantum DAT 160 User’s Guide
29
Figure 17 Setting the SCSI ID
1
Determine whether you need to change the SCSI ID from the default
of 3.
2
Change the tape drive’s SCSI ID, if necessary.
Use a small screwdriver or a ball-point pen to press the indented
Use a small screwdriver or a ball-point pen to press the indented
SCSI ID selector buttons on the rear panel (see
) until the
required value is displayed. Do not use a pencil because small bits of
graphite could contaminate the drive.
Connecting the SCSI
Cable
Cable
3
A wide VHD-to-HD SCSI cable and LVD terminator are provided to
connect your Quantum DAT 160 tape drive to a VHD SCSI port on an
LVD SCSI bus. If your server has an HD SCSI port, you must either
purchase and install a VHD-to-HD adapter or use an HD-to-HD cable
Note:
The computer and the tape drive SCSI IDs are only
checked at power-on. To change the SCSI ID after
installation, power down both the computer and the tape
drive, change the drive’s SCSI ID, power up the tape drive,
and then power up the computer.