Quantum acl 4 Installationsanweisungen

 Appendix B Supplemental Installation Procedures

Loading the Library with Cartridges

ACL 4/52 Facilities Planning and Installation Guide

39

Loading the Library with Cartridges

2

The “Auto-Load” feature must be “Enabled” before performing this 
procedure. If this feature is not currently Enabled, refer to 
“Enabling/Disabling the Auto-Load Feature” on page 36.

Examine all cartridges before loading them into the library 
or tape drive. Look for label stock or other foreign material 
that may be clinging to the cartridges.

With the SDA displaying 

System On-line

, press and release the 

load port OPEN

 button and verify that the indicator begins 

blinking. (After several seconds, the load port door will 
automatically open.)

Mechanical hazards could be exposed when the load port is 
partially open or closed. Do not attempt to insert hands or 
fingers into the load port opening at any time.

With the load port door open, place up to four cartridges in the 
available load port bins. 

Press and release the 

load port CLOSE

 button.

The load port door is LOCKED in the “open” position. You 
must press and release the CLOSE button before 
attempting to close the load port door.

When the 

CLOSE

 Indicator (LED at the upper left corner of 

CLOSE

 button) is steadily lit, push the Load Port door closed. (The 

library will lock the door.)

Repeat Steps 1 through 4 until you have loaded a maximum of 48 
DLT™ cartridges into the library.