Quantum DAT 160 Betriebsanweisung
x
Quickstart
Note
The DAT Autochanger has been shipped with the SCSI ID for the drive
set to "0" and the changer (robotics) set to "3".
set to "0" and the changer (robotics) set to "3".
p Confirm that power is off on your host computer and that you have a SCSI
interface (either a separate board, or integrated on the motherboard) installed in
your host computer. Consult your computer manual.
your host computer. Consult your computer manual.
p Place the DAT Autochanger close to the host computer.
p Connect the SCSI interface cable between the SCSI connectors on the host
computer and the rear of the DAT Autochanger.
Note
adic recommends the use of an “Alt-2” active single ended terminator,
such as adic p/n 61-1124-01.
such as adic p/n 61-1124-01.
Host Computer
SCSI Interface Cable
Terminator
DAT Autochanger