Quantum DAT 160 Betriebsanweisung

8

To confirm that the random access mode is selected, check to be sure that the mode
selection jumper is installed on the mode selection pins on the back of the control
module panel (your DAT Autochanger is shipped from 

adic 

with the jumper

installed).

p Open the DAT Autochanger door. Locate the small circuit board next to the left-

hand hinge. The mode selection pins are located on the underside of the board on
the right side. A jumper should be installed over the pins.

To select the random access mode if the jumper has been removed, simply install the
jumper over the pins.

To confirm that the sequential access mode is selected, check to be sure that the
mode selection jumper is not installed on the mode selection pins on the back of the
control module panel (your DAT Autochanger is shipped from adic with the jumper
installed).

p Open the DAT Autochanger door. Locate the small circuit board next to the left-

hand hinge. The mode selection pins are located on the underside of the board on
the right side. The jumper should not be installed over the pins (see Figure 6).

To select the sequential access mode if the jumper has been installed, simply remove
the jumper from the pins.