Quantum DLT-V4 Betriebsanweisung
Chapter 4 Installing the Internal SATA-to-USB Tape Drive
Unpacking the Internal SATA-to-USB Tape Drive
DLT-V4 Product Manual
25
Unpacking the Internal SATA-to-USB Tape Drive
4
Before you do anything else, unpack and inspect the tape drive for
shipping damage. If you notice any damage, report it both to the sales
representative and to the shipping company immediately.
If there is no damage to the tape drive, select a server or workstation to
host the tape drive, then move on to the following installation steps.
Installing the Internal SATA-to-USB Tape Drive
4
To install the tape drive, follow these steps:
1
Shut down the operating system and power off the server or
workstation.
2
Power off all peripheral devices, such as printers and other connected
devices.
Note:
Save the packing materials in case you need to move or ship
the tape drive in the future. You must ship the tape drive in
the original (or equivalent) packing materials or you will
invalidate the warranty.
Caution:
Do not go to step 3 until you have completed steps 1
and 2. Failure to follow these instructions may result
in damage to the tape drive or other devices.